Making A Money Clip

Click on picture for next

w081212001.jpg
Bending jig, top view

This is the top view of the jig I was instructed to make.

The pair of pegs on the right are spaced just far enough apart for the 16 ga silver to fit between. I used a strip of cardboard about the same thickness to figure out where to put the left-hand peg (the one you fold the strip around).

I made the whole jig 4" long for reasons that will become apparent later.

<Previous Back to Parent Next>

The Engraver's Cafe
My Etsy store.
Back to my simple homepage

1425 views