Enhanced Winchester Lockback

This is a little (well, about 3.5 inch) Winchester 'collectible' knife I picked up and hand engraved.

The engraving was partly for practice and partly to enhance the knife before I gave it away in a gift exchange.

As it turned out I tried a new shading method on the front side and didn't quite like it so I tried another new one on the back - new to me, in both cases, not necessarily never been done before. I like the style I used on the back better.

If you want to see more like this - most much, much better check out either or both of the forums linked to here.

Clicking on the thumbnails will take you to a frame by frame gallery
In the frame-by-frame gallery clicking on the picture takes you to the next picture

Back to my simple homepage
The Lindsay Forums
The Engraver's Cafe

In the tin	The knife, enhanced
Front side	Back of the knife
Signed & Dated	Rear bolster on the back
Rear bolster on the front	Front bolster, front of the knife
Front side, open	Back side, opened

Back to my simple homepage
The Lindsay Forums
The Engraver's Cafe